#COUNTDOWN TIMERS INSTRUCTIONS INSTALL#

When displaying the current date and time, you can press the A button to select the 12 hour mode or 24 hour mode. By pressing the MODE button you can switch between the clock and countdown modes. To display the current date and time, press the MODE button once more. Press the MODE button once again to go into the countdown mode to show the remaining time to your special date. Press the A, B and C buttons to set the current date. x It is recommended to recharge the battery approximately every 4 weeks, or to keep the unit plugged in while in storage. x Fully charge the battery before putting it into storage. Month, date and year will begin flashing. Care Instructions: x Keep the Electronic Two Digit Display dry. Press the A and B buttons to set up the current time (Note the C button does not work in this mode, as seconds cannot be set). At this time, a countdown will be displaying on the screen. Press the MODE button once more to make the clock to go back to the Countdown mode. Setting your clock for current date and time. Note the C button does not work in this Mode as seconds can not be set. if correct hit the right button again, if not hit set and it will advance the year. Press the A and B buttons to set up a special future time. Press the MODE button once again to switch to the Clock Mode (Clock will be appearing on the right upper cor ner of screen) Press the MODE button once again and Hrs, Min and Sec will begin flashing. Hold Clock facing you with 3 buttons on the back. FASS- Front Accessible Service Switch One Minute. Press to increase time Press to reduce time LEDs Orange LEDs indicate timer duration or remaining time in minutes Bottom LED blinks slowly to indicate 1 minute of time remaining. Setting your clock for current date and time. Tap twice quickly - Controlled load turns on with 30 minute countdown timer. Press the A and B buttons to set up a special future time. Press MODE button once again to switch to the next screen where Hrs, Min and Sec are flashing. Using the A, B and C buttons set up a special future date of Month, Date and Year. Press the MODE button for about 3 seconds until Month, Date and Year begin flashing. At this time screen will display 0 for days, hours, minutes and seconds.

#COUNTDOWN TIMERS INSTRUCTIONS INSTALL#

When you install the batteries the clock will be in countdown mode.

Countdown timers instructions